Cabot® Semi-Transparent Deck and Siding
Stain is a deep-penetrating, linseed oil-based
stain that beautify and protect exterior wood. This
lightly pigmented stain enhances the natural
beauty of the wood by allowing the grain, texture,
and color variations within the wood to show
through. Will provide long-lasting, vaporpermeable protection that beautifies and enriches
exterior wood surfaces. Formulated with non-fade,
earth tone pigments to weather slowly over time.
 Water-repellent
 Deep-penetrating oil
 Fade resistant
 Lightly pigmented oil stain for increased UV
protection and color
For use on:
Exterior wood decks, siding, fences and trim. Also
suitable for use on shingles, shakes and roofs.
Especially effective on rough-sawn surfaces.
Apply with a natural bristle brush or professional
spray equipment. When spraying, always
backbrush immediately. To ensure desired
appearance and proper drying time, always finish
a small test area before proceeding. Do not
overapply. Shake and stir thoroughly before and
during use. If project requires more than 1
container, blend all containers together to ensure
uniformity. Apply to small sections at a time (1–
3 boards); start at one edge and follow
through to the end of the boards to avoid lap
marks. Apply 1 coat only. For wood substrates
only.
Airless Spray: Recommended tip sizes and
adjustments are 1000–1500 PSI, 0.013–0.015” tip
with fan width of 8–10”. These recommendations
are a starting point only. Due to variability in
sprayers, we recommend testing your spray
pattern and flow before proceeding. If spraying
large surfaces, be sure to back-brush or roll
immediately after spraying. When using HVLP
spray equipment, see manual for proper set-up
instructions.
The appearance of the finish will vary depending
on the porosity and color of the wood surface. To
ensure desired appearance and proper drying
time, always finish a small test area before
proceeding.
Custom tinted stain is non-refundable.